DLV
Roof batten connectors
With the DLV roof batten connectors, roof panel joints can be anchored on supporting structures, in compliance with the minimum edge distances for the nails.
They are used on narrow rafters, e.g. for nail plates. The DLV roof batten connectors are load-bearing in all directions.
Production Status
discontinued
Marcado CE
DITE
Clase de servicio 2
EPD
Detalles de producto
Imagenes
Características
Aplicaciones
Datos técnicos
Dimensiones
Valores Característicos
Table "Valores Característicos" cannot be displayed : no references available.
- Fasteners in batten are only needed, if force F1 is acting.
- DLV50/30: use always CSA4,0x30 in batten
- Other DLVs: use always CNA4,0x40 in batten
- When using CNA4.0x40 threaded nails in the rafter, the following applies:
- When using nails 3.1x80 or 3.4x90 in the rafter, the following applies:
- All loads must be disassembled into the above-mentioned force components, only lifting values must be taken into account in force direction F2.
- If the DLV is mounted on a counter batten, ensure that the counter batten is sufficiently attached to the rafters for the forces that occur.